FixByModel
i10

Frigidaire i10: Low water fill detected

The tub did not fill with enough water in the allotted time. It is almost always a restricted or shut-off water supply rather than a failed part.

DIY fix

By the FixByModel editorial team · Verified 2026-09 · Researched against manufacturer support & repair references (below)

Most likely causes

  1. Household water supply valve partly or fully closed
  2. Kinked or pinched fill hose restricting flow
  3. Clogged inlet screen or valve from mineral scale
  4. Low household water pressure
  5. Faulty or scaled water inlet valve
The fill path — check in this order
1Supply valve
2Fill hose
3Inlet valve
4Flow meter
5Tub

Schematic illustration of a typical dishwasher — not your exact model.

Before you start — unplug the appliance and turn off the water supply. You'll be working near water and electrical parts, and drained water can be hot. If a step involves the pump, wiring, or opening the cabinet and you're unsure, stop and call a qualified technician.

Step-by-step fix

1Open the supply valveConfirm the water shutoff feeding the dishwasher (usually under the sink) is fully open.
2Check the fill hoseStraighten any kinks in the inlet hose and make sure it is not pinched behind the cabinet.
3Clean the inlet screenWith water and power off, disconnect the fill hose and clear the inlet screen of scale or grit.
4Reset and retryPress Cancel to clear the code, then start a cycle and confirm water enters normally.
5EscalateIf fill still fails with the supply open, have the water inlet valve tested and replaced.

Still showing i10?

If you’ve worked through every step and i10 keeps returning, an internal part likely needs testing and replacement. That’s a job for a qualified appliance technician, who can measure the suspect part against the service-manual spec before replacing it.

Which models this applies to

Frigidaire dishwashers. Frigidaire and Frigidaire Gallery dishwashers with i-series digital fault codes.

FAQ

What does Frigidaire i10 mean?

Low water fill detected. The tub did not fill with enough water in the allotted time. It is almost always a restricted or shut-off water supply rather than a failed part.

What causes Frigidaire i10?

The most likely cause is household water supply valve partly or fully closed. Other causes include Kinked or pinched fill hose restricting flow; Clogged inlet screen or valve from mineral scale; Low household water pressure; Faulty or scaled water inlet valve.

Can I fix Frigidaire i10 myself?

Usually yes. Start by working through the steps above, beginning with: confirm the water shutoff feeding the dishwasher (usually under the sink) is fully open.