FixByModel
bE

Samsung bE: Stuck or shorted control-panel button

The dishwasher detects a button on the control panel that is stuck down or shorted. It's often caused by a jammed key, a dirty panel, or a failing touch panel.

May need a technician

By the FixByModel editorial team · Verified 2026-09 · Researched against manufacturer support & repair references (below)

Most likely causes

  1. A button physically stuck or jammed
  2. Dirt or moisture on the control panel
  3. Shorted button or membrane
  4. Control panel / board fault
Before you start — unplug the appliance and turn off the water supply. You'll be working near water and electrical parts, and drained water can be hot. If a step involves the pump, wiring, or opening the cabinet and you're unsure, stop and call a qualified technician.

Step-by-step fix

1Press each buttonPress every button firmly to free any that are stuck.
2Clean the panelWipe the control panel to remove dirt or moisture around the buttons.
3Power resetTurn the dishwasher off at the breaker briefly, then restore power and retest.
4Call for serviceIf bE continues, the button/touch panel or control board likely needs replacement.

Still showing bE?

If you’ve worked through every step and bE keeps returning, an internal part likely needs testing and replacement. That’s a job for a qualified appliance technician, who can measure the suspect part against the service-manual spec before replacing it.

Which models this applies to

Samsung dishwashers. Most Samsung dishwashers; also shown as 6E on some models for the stuck-button fault.

FAQ

What does Samsung bE mean?

Stuck or shorted control-panel button. The dishwasher detects a button on the control panel that is stuck down or shorted. It's often caused by a jammed key, a dirty panel, or a failing touch panel.

What causes Samsung bE?

The most likely cause is a button physically stuck or jammed. Other causes include Dirt or moisture on the control panel; Shorted button or membrane; Control panel / board fault.

Can I fix Samsung bE myself?

Some checks are DIY, but this code often points to an internal component, so it may need a qualified technician.