FixByModel
F8E1

Maytag F8E1: Long fill / low water flow

The washer is not sensing enough water entering the tub during the fill, so it stops and flags a fill problem. It usually points to a restricted water supply rather than a failed part.

DIY fix

By the FixByModel editorial team · Verified 2026-09 · Researched against manufacturer support & repair references (below)

Most likely causes

  1. Hot or cold supply faucet not fully open
  2. Kinked or crushed fill hose
  3. Clogged inlet screens from mineral or debris buildup
  4. Water inlet valve failure
  5. Faulty water-level (pressure) sensor
The fill path — check in this order
1Tap
2Inlet hose
3Inlet screen
4Inlet valve
5Tub

Schematic illustration of a typical washing machine — not your exact model.

Before you start — unplug the appliance and turn off the water supply. You'll be working near water and electrical parts, and drained water can be hot. If a step involves the pump, wiring, or opening the cabinet and you're unsure, stop and call a qualified technician.

Step-by-step fix

1Open both faucetsMake sure both the hot and cold supply valves behind the washer are turned fully on; both hoses must be connected even for cold-only cycles.
2Straighten the hosesCheck the fill hoses for kinks or crimps and reposition the washer if a hose is pinched against the wall.
3Clean the inlet screensTurn off the water, unthread the fill hoses, and gently brush any debris off the small mesh screens at the valve inlets.
4Let the drain routine finishThe washer runs an 8-10 minute drain routine after this code; wait at least 10 minutes before restarting a cycle.
5Call for service if it repeatsIf water pressure and hoses are fine but the code returns, the inlet valve or water-level sensor may need replacement.

Still showing F8E1?

If you’ve worked through every step and F8E1 keeps returning, an internal part likely needs testing and replacement. That’s a job for a qualified appliance technician, who can measure the suspect part against the service-manual spec before replacing it.

Which models this applies to

Maytag washing machines. Top-load HE (Bravos/Centennial) and front-load/Maxima washers on the Whirlpool VMW/Maxima platform

FAQ

What does Maytag F8E1 mean?

Long fill / low water flow. The washer is not sensing enough water entering the tub during the fill, so it stops and flags a fill problem. It usually points to a restricted water supply rather than a failed part.

What causes Maytag F8E1?

The most likely cause is hot or cold supply faucet not fully open. Other causes include Kinked or crushed fill hose; Clogged inlet screens from mineral or debris buildup; Water inlet valve failure; Faulty water-level (pressure) sensor.

Can I fix Maytag F8E1 myself?

Usually yes. Start by working through the steps above, beginning with: make sure both the hot and cold supply valves behind the washer are turned fully on; both hoses must be connected even for cold-only cycles.