FixByModel
E11

Frigidaire E11: Water fills too slowly

The washer did not reach its target water level within the allowed time. It usually points to a restricted water supply rather than a broken part. Some models show this as E10.

DIY fix

By the FixByModel editorial team · Verified 2026-09 · Researched against manufacturer support & repair references (below)

Most likely causes

  1. Supply faucets not fully open or turned off
  2. Kinked or crushed fill hoses behind the machine
  3. Clogged inlet screens from hard-water sediment
  4. Low household water pressure
  5. Failed water inlet valve solenoid
The fill path — check in this order
1Tap
2Inlet hose
3Inlet screen
4Inlet valve
5Tub

Schematic illustration of a typical washing machine — not your exact model.

Before you start — unplug the appliance and turn off the water supply. You'll be working near water and electrical parts, and drained water can be hot. If a step involves the pump, wiring, or opening the cabinet and you're unsure, stop and call a qualified technician.

Step-by-step fix

1Check the tapsConfirm both hot and cold supply valves are fully open and delivering good pressure.
2Inspect the hosesStraighten any kinks in the fill hoses and make sure they are not pinched behind the washer.
3Clean the inlet screensTurn off the water, unthread the fill hoses, and rinse the small mesh filters in the valve inlets.
4Restart a cycleCancel, unplug for a minute to clear the code, then run a fresh cycle to see if it fills normally.
5Replace the inlet valveIf filling is still slow with good water pressure, the inlet valve assembly likely needs replacing.

Still showing E11?

If you’ve worked through every step and E11 keeps returning, an internal part likely needs testing and replacement. That’s a job for a qualified appliance technician, who can measure the suspect part against the service-manual spec before replacing it.

Which models this applies to

Frigidaire washing machines. Front-load models (Affinity, Gallery, Professional); some displays show E10 for the same fill fault

FAQ

What does Frigidaire E11 mean?

Water fills too slowly. The washer did not reach its target water level within the allowed time. It usually points to a restricted water supply rather than a broken part. Some models show this as E10.

What causes Frigidaire E11?

The most likely cause is supply faucets not fully open or turned off. Other causes include Kinked or crushed fill hoses behind the machine; Clogged inlet screens from hard-water sediment; Low household water pressure; Failed water inlet valve solenoid.

Can I fix Frigidaire E11 myself?

Usually yes. Start by working through the steps above, beginning with: confirm both hot and cold supply valves are fully open and delivering good pressure.